ASTROAI G22 12 Volt Car Refrigerator User Manual

ASTROAI-G22-12-Volt-Car-Refrigerator-FEATURED

AstroAI

ASTROAI G22 12 Volt Car Refrigerator

ASTROAI-G22-12-Volt-Car-Refrigerator-PRODUCT

INTRODUCTION – AstroAI

Thank you for purchasing the AstroAl portable freezer. This is a portable freezer that can be used with both a 12/24 volt car outlet and a standard wall outlet. We hope you enjoy your new Portable Freezer! If you have questions or concerns contact us via support@astroai.com

Please fully read and follow this manual before using this product; keep this manual for future reference.

SAFETY INFORMATION

  • When using the 12/24 V in-car adapter, the compact fridge should not be left connected for long periods when the engine is not running.
  • Unplug this device during lightning storms or when not in use for long periods to prevent damage.
  • DO NOT open or remove covers, doing so may expose you to dangerous voltages or other hazards.
  • The supply voltage should be the same as that indicated in the technical specifications and the appliance rating plate.
  • To disconnect the device from a power source, switch off the outlet and completely remove the plugs.
  • Do not bend, stretch, or pull the power supply cable. Doing so may result in an electric shock.
  • Avoid using locations where dust or other airborne contamination may be drawn into the fan.
  • Allow at least 5 inches of distance from the back and sides of the device to allow proper air circulation and heat dispersal.
  • Never leave the fridge running in poorly ventilated areas e.g. a car’s trunk.
  • The installation of DC power on board must be performed by a professional electrician.
  • Do not use electrical products inside the freezer.
  • After initially unpacking the freezer, let it stand for at least 6 hours before powering on.
  • Keep the freezer horizontal at all times.
  • The freezer should be operated in a well-ventilated area away from heat sources and direct sunlight.
  • Do not soak the freezer with water. If water accumulates inside the freezer, use a cloth to dry out the condensation. Do not pour water out of the freezer.

DIAGRAM

ASTROAI-G22-12-Volt-Car-Refrigerator-FIG-1 ASTROAI-G22-12-Volt-Car-Refrigerator-FIG-2

  1. Magnetic Door Handle
  2. Control Panel
  3. Carrying Handle
  4. Heat Dissipation Port
  5. Power Port
  6. Drain Plug
  7. LED Light
  8. Fast Ice-Making Area
  9. Ice Cube Tray
  10. AC Cord and Plug
  11. DC Cord and Plug

DISPLAY INTRODUCTION

ASTROAI-G22-12-Volt-Car-Refrigerator-FIG-3

  1. Power Button
  2. Set Button
  3. Increase Temperature
  4. Decrease Temperature
  5. Child Safety Lock
  6. USB Charging Port

SIZE DESCRIPTION

ASTROAI-G22-12-Volt-Car-Refrigerator-FIG-4

SPECIFICATIONS

  • Product Name: Car Fridge And Freezer
  • Model: G22
  • Capacity: 22 L
  • Climatic Category: T, ST, N, SN
  • Rated Voltage AC (Adaptor): 100 V-240 V; 50/60 Hz
  • Rated Voltage DC: 12 V/24 V =
  • Rated Current for AC (Adaptor): 1.2 A – 0.5 A
  • Rated Current for DC: 5.0 A (12 V)/ 2.5 A (24 V)
  • Refrigerant: R134a 0.85 oz (24 g)
  • Foam Vesicant: CsH1o/C-Pentane
  • Certifications: CE,GS,FCC,cTUVus
  • Protective Classification of Electric Shock Resistance:
  • Important Note: After initially unpacking the freezer, let it stand for at least 6 hours before powering on. Always keep the freezer horizontal.

OPERATION INSTRUCTIONS

  1. Connect the power supply: Plug the power cable into the freezer’s socket.ASTROAI-G22-12-Volt-Car-Refrigerator-FIG-5
  2. Connect the other end to a car cigarette lighter or a standard household outlet.ASTROAI-G22-12-Volt-Car-Refrigerator-FIG-6
  3. Press the “POWER OFF” button to turn the freezer on to cooling mode. The temperature on the display is the current internal temperature.
    Note: This freezer has a Child Safety Lock function. If there is no operation within 10 seconds after starting the freezer, the screen will be automatically locked, and “LOCK” will be displayed. At this time, none of the buttons will work except the unlock button; press and hold the unlock button for 2 seconds to unlock and the “LOCK” symbol on the screen disappears.
  4. Press the “+” or “—” button to set the cooling temperature. Hold “+ ” or “—” to quickly increase/decrease the temperature.
    Note: The first time you use the freezer, it will default to the lowest temperature. In subsequent uses, the temperature will default to the last user-set temperature.
  5. Press the “SETTING” button to change the freezer to ECO (Energy Saving Mode) or MAX (Fast Cooling Mode). The factory default mode is MAX.
  6. Press the “POWER OFF” button to turn off the freezer.

BATTERY PROTECTION SETTING

This freezer has a three-level battery protection function which not only guarantees the normal operation of the freezer but also protects the battery of the vehicle.

  1. Set the freezer to its “on” state.
  2. Long press the “SETTING” button until the display flashes “H”.
  3. Press the “SETTING” button again to select a low voltage protection level “L”, medium voltage protection level “M”, or high voltage protection level “H”. The factory default is “H”.

BATTERY PROTECTION

L/M/H

  • 8.5-10.9 V 10.1-11.4 V 11.1-12.4 V
  • Vehicle Battery External Battery or Spare Battery

Note: Due to the different output voltages of different vehicle power supplies, if the voltage protection appears (if the display reads “F1”), you can lower the battery protection setting by one level (“H” adjusted to “M” or “L”).

We do not recommend that you run the freezer while the engine is off.  If you must run the freezer while the engine is off, set the protection level to “H” (high). If the freezer runs for too long without the engine on, the vehicle may not be able to start.

TEMPERATURE UNIT SWITCHING

  1. Set the freezer to its ” off ” state.
  2. Press and hold the “SETTING” button until the display reads “Е1”.
  3. Press the “+” or “—” button to switch between Fahrenheit and Celsius.

TROUBLESHOOTING

The freezer is not working

  • Check if the power supply is faulty.
  • Check the plug to ensure it is in good contact.
  • Check if the cigarette lighter fuse has blown.
  • Check if the power switch on the display panel is on.
  • After turning the freezer on, there is a three-minute compressor delay safety. Check if the freezer turns on after three minutes.
  • Check if the compressor turns on.

It sounds like water is running inside the freezer This is the normal sound of flowing refrigerant.

Excessive freezing inside the refrigerator

  • The temperature is set too low.
  • Confirm the door is closed and the seal is intact.
  • Make sure the inside of the freezer is dry before use.

Water droplets accumulate around the shell or door seal

When the moisture in the air meets the cold shell of the freezer, it condenses into water droplets. This condensation can be wiped off with a towel.

The compressor starts loudly

When the compressor initially starts, the motor will usually run at a high speed. This produces a loud noise, but it will decrease after the speed has stabilized.

Inaccurate temperature displayed

  • If items put inside are too hot, the internal temperature will be uneven while the temperature stabilizes.
  • Frequently opening and closing the freezer door causes varying airflow, resulting in an unstable internal temperature.
  • Make sure that the unit of your thermometer matches the unit of the freezer display.

CODE ANALYSIS

  • F1 Low voltage protection code: Lower the battery protection setting by one level.
  • F2 Overloaded protection for the fan: Turn the freezer off and leave it unplugged for 30 minutes before restarting. If the error occurs again, please contact AstroAI Customer Support for help.
  • F3 Protection for frequently started compressor: Turn the freezer off and leave it unplugged for 30 minutes before restarting. If the error occurs again, please contact AstroAI Customer Support for help.
  • F4 The speed of the compressor is too low or the load is too large: Turn the freezer off and leave it unplugged for 30 minutes before restarting. If the error occurs again, please contact AstroAI Customer Support for help.
  • F5 High-temperature protection for the compressor: Turn the freezer off and leave it unplugged for 30 minutes in a well-ventilated area before restarting. If the error occurs again, please contact AstroAI Customer Support for help.
  • F6 The controller can not check the parameters: Turn the freezer off and restart it. If the error occurs again, please contact AstroAI Customer Support for help.
  • F7/F8 Abnormality in the thermistor: Please contact AstroAI customer service.

WARRANTY PERIOD

2-Year Limited Warranty from AstroAI. Each AstroAI Portable Air Compressor will be free from defects in material and workmanship. This warranty does not cover damage from neglect, misuse, contamination, alteration, accident, or abnormal conditions of operation or handling.

This warranty covers the original purchaser only and is not transferable. AstroAI always wants to provide our customers with excellent products and customer service.

Questions or concerns? We’re happy to help! Please contact us via  support@astroai.com

FAQs About ASTROAI G22 12 Volt Car Refrigerator

What’s the operation of a 12V vehicle fridge?

A low-power compressor in a compressor refrigerator runs on electricity and then pumps refrigerant through the cooling system. A specialized 12V or 24V compressor meant for use in moving vehicles powers DC refrigerators.

My 12V fridge isn’t cooling; why is that?

Your 12V refrigerator may not be cooling for several reasons, such as a low refrigerant level, a filthy condenser coil, clogged air vents, a damaged compressor, and a broken thermostat.

What is the wattage required by a 12V refrigerator?

Compressor fridge at 12 volts, 40 watts Pump for water – 10 watts LED lights: fifteen watts Battery gauge: 0.4 watts

What’s the runtime of a 12V refrigerator?

Based on the assumption that your auxiliary battery contains 100 Ah of usable energy, you could operate your 12V refrigerator for five to six days.

How should a 12V fridge be powered?

The first, and simplest, is just connecting it to the 12-volt cigarette lighter outlet directly in your car. If your journey is shorter, you plan to drive most of the way, or you have access to a powered campsite when you get there, this approach will work nicely.

What is the amps of a 12-volt fridge?

This indicates that when the refrigerator is operating, it uses about 10 amps of electricity.

Are vents necessary for vehicle refrigerators?

For a gas-absorption type refrigerator, proper ventilation is essential for several reasons related to performance and safety. These are to ensure that: – the living area of the vehicle is isolated from the refrigerator’s combustion system; and – that there is an adequate intake of fresh air to support combustion.

What is the ideal car fridge size?

40L refrigerators, the most popular or “standard” size, are perfect for a long weekend for two or three people.

For a 12V refrigerator, what size cable should I use?

A minimum of 6 millimeters in diameter for the cable will guarantee optimal performance from your refrigerator. Either twin-core or single-core wire enables an earth run to the battery.

Is it safe to drive when a 12-volt refrigerator is running?

Indeed! When driving or off-grid camping, you can power a refrigerator with battery power, but there are a few things to think about to know if you have enough battery capacity.

For More Manuals by AstroAI, Visit Latest Manuals

ASTROAI G22 12 Volt Car Refrigerator User Manual 10 ASTROAI G22 12 Volt Car Refrigerator [pdf] User Manual

Leave a Reply